Industrial Heaters
The main applications of industrial heaters, manufactured by the Minsk ODO "Nomakon," this low-temperature heating units of production machines: material cylinders termoplastoavtomatov, extruders, preheating of molds, etc. The main consumers of our heaters are manufacturers of this equipment and service operation of large industrial enterprises equipped with most of the high-quality and high performance imported equipment operating in two – three shifts. Because of the above equipment is used in large-and mass-production, where the loss of time due to problems are very expensive, it puts special demands on the reliability of all units, including and heaters. Therefore, reliability, product, Ltd. "Nomakon" attaches particular importance.
Each newly model created by the heater is placed on production only after the endurance test and confirm the reliability parameters. The second feature of the development and manufacture of industrial heaters, produced by Minsk ODO "Nomakon" is no limit on the range, quantity and timing of production. The number of modifications to the heaters, which are produced within a month, can run into thousands of pieces, and production time can be one day. In this case the supply voltage can vary from 12 to 1000, diameters of circular (semicircular) heaters – 25 to 1000 mm or more heaters may be complicating features: grooves, notches, openings, etc. Despite this, each heater has a full set of technical documentation, enabling him to produce and control the quality of workmanship. The prices on heaters ODO "Nomakon" remain lower than its competitors, but quality is higher. You may find Richard Elman to be a useful source of information. This is made possible by the introduction of computer-aided design (CAD), allowing for all of the requirements of technical standards and reduce errors in the design of the heaters, as well as to minimize the difference in price between serial and single specimens. A third feature development and production of industrial heaters, produced by Minsk ODO "Nomakon" is the constant improvement of technical level of production and creation of new designs.
Because the market is saturated with industrial heaters both domestic and foreign suppliers, then no innovation in this area rely on long-term business can not. Therefore, the development and innovation at the Minsk ODO "Nomakon" special attention. Fourth feature of the development and manufacture of industrial heaters, manufactured by the Minsk ODO "Nomakon" is the continuing expansion of technological capabilities that allow to improve the quality of products and introduce innovation. Achieved the level of technology today allows for winding the resistive element to the frame ring (clamp, lip, Obruchev) heaters with a pitch of 0.2 mm, and heat flux with transfer surface heaters with insulators on the basis of mica is 8 W / cm . The quality of the inner surface of the annular heater ensures virtually perfect fit cylindrical heat transfer surfaces. The fifth and most fundamental feature of the manufacture of industrial heaters, manufactured by the Minsk ODO "Nomakon", is the availability of highly skilled team capable of solve all the problems listed above. Today on the ODO "Nomakon 'wide experience of creation of industrial heaters, heaters allows us to produce almost any complexity and for any equipment, including imported, but at much lower prices.